Have you ever encountered this embarrassing situation of the buttons dropped buttons?
After wearing the clothes for a long time, the button may fall off. After it is sewn, the reason is that the method of sewing the button is wrong. So how to sew the buttons is correct? Let me share a method of how to sew the buttons without falling.
Preparation materials: The materials and tools required for sewing buttons include clothing, suitable buttons, needles, needles, about 60 cm long lines (color and clothing to match), big head or bead needle, scissors.
The flat buttons are the most common and most common buttons. They are generally used on some shirts and sweater, usually with two -hole and 4 holes.
1. Cut the threading lead about 60 cm long lines. After passing through the needle eye on one end, the two ends of the line are pinched together to make the line a dual -share line. It is large enough to avoid being fixed on the side of the fabric when suture.
2. Determine the position of the buttons flattened the cuffs on the countertop. Use the bead needle through the middle of the buckle until the lower layer fabric, and then open the cuffs. At this time, the position of the bead needle is the position of the button to be fixed.
3. The needle on the back is close to the "mark needle" position, wears from the bottom of the fabric to the top, and then take the marking needle, tighten the line until you feel that the thread is on the other side of the fabric. Live.
4. Pass the small holes on the button to let the needle pass through any small holes on the button from the bottom to top, and then wear a small hole from top to bottom from top to bottom, then wear back to the fabric Fix the buttons on the fabric. Then the needle passes the fabric upwards, passes through the first small hole, passes through the diagonal holes, and goes back to the back ... so repeated 2-3 times.
5. Pass the remaining holes and wear the remaining holes in the remaining method.
6. The winding foot of the winding foot is not necessary. But if there are around the other buttons, of course, this button you sew will be around. Put the needle back to the fabric, wrap the "wiring beam" of the "wire beam" below the button and between the fabric, and then wear the needle to be under the fabric. This step can form a small space between the fabric and the buttons, which is more convenient to use the button.
7. In order to fix the wire head, we need to sew a needle in the horizontal side of the thread under the clothes, but the wires are not tightened, and it is pulled up to form a wire. Then, pass the needle through this ring, and then tighten the line, as if a single knot. You can repeat 2-3 times by pressing this method.
8. Cut off the excess line to cut off the excess lines near the fabric. Such a button is sewn.
